Little Gift Box

Today’s post brings you a Little Gift Box which is made using the Envelope Punch Board. I haven’t used my Envelope Punch Board in quite some time and it shows in the video :). So, I decided to dust it off, so to speak, and make this Little Gift Box. This Little Gift Box would be great to use for a small gift for any occasion, however today i make it for Christmas.

Little Gift Box

These boxes are quick and easy and can be made from Designer Series Paper or Card Stock. Just make sure you have an Envelope Punch Board. It can be used not just for envelopes but for treat pouches and boxes as well. Watch the video to see how I made this box today:

Did you learn something from this video? If so, please subscribe to my YouTube Channel.
Thank you for subscribing. I appreciate your support.

Little Gift Box Measurements

  • Card/D.S.P. should measure 5 1/8″ x 5 1/8″ or 12.9 cm x 12.9 cm
  • 1st punch is at 1 /8″ or 4.6 cm
  • 2nd punch is at 3 1/4″ or 8.2 cm
  • Ribbon – enough to tie around the box

Remember to make the bottom you need to increase your 1st and 2nd punch measurements by a small amount say about 1/16″ or 0.02 cm. The bottom needs to be slightly smaller than the top.

Little Gift Box 1

Next Video will be a larger box using Designer Series paper, so op back then for more on the Envelope Punch Board.

Thank you for stopping by today and I hope you come back again soon to see what else I have to share.

Remember, your creativeness is only limited by your imagination. Keep smiling and until next we share…

Are you looking for a hobby, part or full-time job and be able to work from home and when it suits you? Do you love craft? Then you should consider doing what I do.
To learn more, visit my website.

Earn FREE Stamps With Libby rewards program – print your copy HERE.

I WOULD LOVE TO BE YOUR DEMONSTRATOR!

Products1
 

Heat Tool

$50.00

Leave a Reply

Your email address will not be published. Required fields are marked *